Install vinyl stickers in seven steps!

Installing vinyl stickers is not rocket science. It is a very simple task that can be accomplished by following some steps mentioned below. So go through the list of next steps for the right methods to install the printed vinyl stickers of your dreams.

[Step-1] Look for a perfect surface:

Before you take any other steps to install a printed window sticker or vinyl sticker, you need to make sure you have a clean, smooth, and dry surface. It’s important because if you stick your car window decal on a dirty surface, the glue that is attached to the back of the decal will pick up that dirt, which in turn will not allow the decal to stick to your surface. properly.

[Step-2] Clean the surface properly:

If the surface is not clean enough, your next job is to make the surface spotless, dirt free, grease free, crystal clear and clear. The best surface cleaner available, in this case, is isopropyl alcohol, especially since it dries in just a few seconds and leaves no residue. You can also use other regular cleaners like water, household detergent, and any other dry cleaners. However, do not use harsh cleaners like Windex. They often leave a lot of residue and don’t allow the sticker to adhere well.

[Step-3] Mark the area:

Once you are done with the above mentioned tasks, mark a particular area of ​​the entire clean surface. Use masking tape to mark the required measurement, usually from left to right and top to bottom. Now leave this as it is.

[Step4] Remove that white paper:

All kinds of promotional stickers or vinyl decals are often adhered to a white backing paper that actually protects the decal glue from air and moisture. Here, you have to slowly peel off that white background and extract the actual sticker.

[Step5] Place the sticker:

Now slowly place the promotional window sticker inside the marked area and affix it there. Don’t forget to rub the surface of the sticker with a squeegee or credit card. This will remove any air bubbles below the surface of the label.

[Step6] Peel the transparent tapes:

Last but not least, slowly peel off the clear transparent tape, at a comfortable angle. Do it slowly and don’t pull the sticker from your surface.

[Step7] Some extra care:

You can use a pin or a pointed object to pry out the existing bubble. For best results, do not attempt to adhere the label in an extremely hot or extremely cold environment. The preferable temperature to apply these car window clings is 70 degrees Fahrenheit.